Facial 55

Suggested Sampler: DPM++ 2M KarrasWeight: 0.2-1Further down is a guide on how to use and control it and also an example on how to use it in combination with inpaint or img2img.Version 1.0More subtle, better to control.Version 2.0More cum, works a bit better with dark skin. Experiment with different weights of the lora and use ADetailer to improve quality.How to control it?If you want to have some control over it, you can play around with the weight of the LoRA itself or with the weight of the prompt. In these cases I recommend to use only the cumfacial55 prompt.Prompt weightI got the best results when playing around with the prompt weight and leave the weight of the LoRA. Here is an example using the prompt:lora:cumfacial55:1, woman, face, close-up, cumfacial55:1.0The LoRA weight stays at 1. The prompt weight for cumfacial55 changes from 1.0 to 0.6 and then to 0.2LoRA weightYou can also use the LoRA weight to get the desired effect. Here is an example using the prompt:lora:cumfacial55:1.0, woman, face, close-up, cumfacial55Here the LoRA weight is changed from 1.0 to 0.6 and finally 0.2:LoRA and Prompt weightIf you want even more control, you can modify both weights to get a very subtle effect.Here the LoRA weight is locked at 0.5, while the prompt weight changes from 1.0 to 0.6 and finally to 0.2:And here the Prompt weight is locked at 0.5 and the LoRA weight changes from 1.0 to 0.6 and 0.2:How to Inpaintas usual, there are multiple way. As an example, let's use an image from my fictional model stella hereThe lazy wayUse img2img and go with a simple prompt and a very low denoising strength!load the image and keep the prompt very simple:lora:cumfacial55_v2:0.8 cumfacial55Sampler: Euler,Resize by: 1CFG Scale: 7Denoising strength: 0,1You end up with something like this:Not that bad, considering we put almost no effort into it. In most cases it modifies the mouth and the chin a bit, but all in all it's acceptable.InpaintIf you have a more complex image and/or just want certain parts of the image to change, you need to use Inpaint.Load the picture, paint in the area that you want to change. Prompt is very simple:lora:cumfacial55_v2:0.8 cumfacial55Mask mode: Inpaint maskedMasked content: originalInpaint area: Only maskedUse a higher Denoising strength, you need to experiment a bit: 0.25-0.4 worked fairly well for me, but it depends on your image.In this example I only painted in one side of her face and the chest area. You end up with something like this:Target only the faceIf you want to target only the face, the easiest way is to have normal prompt and then use ADetailer with a face model and have a dedicated prompt like lora:cumfacial55_v2:0.8 cumfacial55 only for ADetailer.That will give you something like this:As an alternative you can use Inpaint yourself, but ADetailer pretty much does that for you in a faster and easier way.