Він не пройшов нашу перевірку контенту — не хвилюйтеся, вашу модель і надалі можна повністю шукати та використовувати!
Просто замініть обкладинку на ту, що підійде для всіх.
Завантажено
25 бер. 2024 р., 23:17
Використань
246
Відгуки
Немає відгуків
Дозволи
Allow image generation & sharing
Дозволити користувачам завантажувати вашу модель
Комерційне використання
Опис
Just wanted to tweak a bit the view angle. The LECO ended up quite gentle and linear. I could train it further but i don't normally do big adjustment in the view angle, so I am fine with the granularity. If you wish to start higher or lower you can use From_Above and From_Below and do fine adjustments with the LECO.For me it was stable from -5 to 5 I didn't have time to check further.Until the XYZ plot was finished did i finally realize that i am dumb and you can't have a from_below angle for the on_back position because you would be inside the bed. :PLECOs are manipulated by their weight and normally need no triggers to use it, change their weight like this lora:AboveBelowView:-1 to lower the "camera" lora:AboveBelowView:1 to Rise the camera. Remember you can go further than -1 or 1!
